The baby mask is designed to make administration of the Metered – Dose Inhaler through Zerostat Spacer device to infants and children easier.

Baby mask helps your child obtain full benefit of the medicine released by the inhaler into the Zerostat Spacer. With the help of Baby Mask a child can easily inhale the medicine, while breathing in and out through the mouth normally.

	Step 1 Assemble the Zerostat Spacer and fit the Baby Mask onto the Zerostat Spacer mouthpiece. Visually check that the assembled Zerostat Spacer with Baby Mask is clean.
	Step 2 Remove the protection cap from the inhaler and check that the mouthpiece is clean.
	Step 3 Shake the inhaler well.
	Step 4 Insert the inhaler into the opposite end of the Zerostat Spacer. The Zerostat Spacer with Baby Mask is now ready for use.
	Step 5 Sit or lay the child on your lap and hold the baby mask firmly over the mouth and nose with the Zerostat Spacer and inhaler upright as shown.
	Step 6 Press the canister to release a dose of medicine into the Zerostat Spacer. Hold the Baby Mask in place for seconds while the child breathes normally.

• After use, remove the baby mask from the Zerostat Spacer.

 
• For subsequent use reassembled zerostat Spacer and attach the baby mask as given in the instructions.

 
• It is required to change the baby mask after six months of continuous use.

• Rinse the baby mask and the two halves of the Zerostat Spacer in warm water. A mild detergent or a solution of the type used to clean babies’ feeding bottles may be added to the water .Then rinse thoroughly with clean water.

 
•  Baby Mask - Shake well to remove excess water leave to dry without the use of heat.

 
• Zerostat Spacer – wipe dry with a soft cloth (do not use heat).

 
• Baby mask should be cleaned regularly, preferably twice a week. 

Important
Use the Baby Mask as directed by the physician.